燃烧室头部激励的等离子体强化燃烧特性实验研究

等离子体助燃是一种新型的强化燃烧技术，近年来受到国内外学者的广泛关注。本文开创性地研制了基于旋转滑动弧等离子体的强化燃烧头部，建立了某型航空发动机三头部燃烧室实验件的等离子体助燃实验平台，验证了该等离子体强化燃烧技术应用于型号发动机燃烧室的可行性。实验研究等离子体助燃在不同余气系数和不同输入电压条件下对平均出口温度、燃烧效率、温度分布系数以及熄火边界的影响。实验结果表明，与正常燃烧相比，施加等离子体助燃后的燃烧效率有明显的提高，在输入电压为U0=240V，余气系数为 α=0.8时，等离子体助燃的燃烧效率提高3.24%。实施等离子体助燃后，燃烧室出口温度分布场分布得到明显的改善，在富油工况α=0.8，出口温度分布系数减少39.8%。等离子体助燃输入电压越高熄火边界扩展程度越明显，相比于正常工况条件下，等离子体助燃U0=240V的熄火边界扩宽了7.34%。     

基于模态反转的半球谐振陀螺零位自校准方法

针对半球谐振陀螺的零位漂移问题，本文研究了基于模态反转电路控制技术的零位自校准方法。首先，从动力学模型引入阻尼不对称、频率裂解等非理想因素，讨论半球谐振陀螺的工作机理及驻波漂移特性。其次，通过理论分析模态反转的零位校准以及虚拟进动控制的模态反转技术。最后，基于FPGA数字控制平台，设计并实现了半球谐振陀螺零位自校准半实物仿真实验。实验结果表明，基于模态反转的半球谐振陀螺零位校准，实现了半球谐振陀螺的零位从15 降低至2 ，短期零偏稳定性和长期稳定性也分别提高了11.8％和45.86％，有效地抑制了零位漂移，提高了半球谐振陀螺测量精度。     

不同直径圆球诱导燃烧的振荡机制与频率特性

为了分析不同直径圆球诱导振荡燃烧的规律，并揭示圆球大小在振荡燃烧现象中所发挥的深层次作用，本文采用二维轴对称Euler方程和基元反应模型，对不同直径的圆球在H2/air预混气体中诱导振荡燃烧的现象开展数值模拟研究。研究发现，振荡频率并不是简单地随直径增大而逐渐从高频向低频连续过渡，而是存在两次突变，形成了超高频、高频以及低频三种振荡燃烧模态。在两种模态间过渡时，振荡达到稳定状态前，会存在一段双频耦合的振荡阶段。三种不同振荡燃烧模态的产生是受到了不同振荡机制的作用，而两种模态间过渡时的双频耦合现象则是两种机制相互竞争的结果。     

四旋翼倾转飞行器操纵冗余设计

建立了四旋翼倾转飞行器旋翼、机翼、机身的非线性气动模型和飞行动力学模型,并在Matlab/Simulink环境下搭建了仿真模型,根据仿真模型计算各个操纵面的操纵效率,确定了不同状态下各个通道需要用到的操纵方式,结合飞行动力学模型和操纵方式,在纵向通道上进行了全包线的配平计算,表明了操纵策略的可行性。     

Effect of bristle pack position on the rotordynamic characteristics of brush-labyrinth seals at various operating conditions

Over the last few decades, the research on the effect of bristle pack position on the rotordynamic characteristics of the brush-labyrinth seals is not sufficient. To this end, two kinds of brush-labyrinth seals for the bristle pack element installed upstream of the labyrinth teeth named BSU and installed downstream of the labyrinth teeth called BSD were used to investigate the effect of bristle pack position on the rotordynamic characteristics of the brush-labyrinth seals. Using the numerical model combining the porous medium model and the whirling rotor method, the rotordynamic characteristics of the BSU and BSD at various operating conditions including four kinds of pressure ratios, five kinds of inlet preswirl speeds and four kinds of rotor spinning speeds were conducted. The obtained results show that the effects of operating conditions on rotordynamic coefficients for the different seal configurations are different. The direct stiffness, cross-coupled stiffness and direct damping of the BSU are lower than those of the BSD. The rotordynamic coefficients of the BSU are more insensitive to the operating conditions variation. From the perspective of the seal stability, the BSU is a better brush-labyrinth seal configuration at high pressure ratio, high positive preswirl or high rotor spinning speed conditions. While in the case of low pressure ratio, low positive preswirl or low rotor spinning speed conditions, the BSD is a better choice.     

直升机后缘襟翼驱动器迟滞现象仿真与抑制

直升机后缘襟翼多采用压电驱动器作为驱动元件，但是在使用过程中压电驱动器迟滞会对其振动控制性能产生不利影响，因此针对压电驱动器迟滞开展了迟滞建模与抑制研究。通过实验研究了压电驱动器在不同驱动频率下的迟滞特性，采用Bouc-Wen模型对驱动器迟滞现象进行了建模，并采用粒子群算法（PSO）辨识模型参数，与实际测量迟滞曲线进行了对比，在10~60 Hz范围内所建立的迟滞模型能够较为精确地描述压电驱动器迟滞现象。建立了基于Bouc-Wen逆模型的前馈补偿控制与PID反馈控制相结合的复合控制策略，实验结果显示该控制策略能够在10~60 Hz较宽的频率范围内有效抑制该压电驱动器迟滞现象。建立了考虑驱动器迟滞的主动控制后缘襟翼振动控制动力学模型，并对中等速度稳态前飞条件下后缘襟翼振动控制性能进行了仿真，仿真结果显示驱动器迟滞会在一定程度上削弱振动控制性能，而采用复合控制可以提高后缘襟翼旋翼振动控制性能。     

多支点柔性转子系统临界转速稳健设计方法

基于响应面法和容差模型提出了定量考虑参数变差影响的转子系统临界转速稳健设计方法。该方法利用响应面模型获得多参数、多目标之间的函数关系,并以多阶临界转速分布为约束条件、以临界转速对支承刚度变差敏感度最低为设计目标。对小涵道比涡扇发动机低压转子系统临界转速稳健设计结果表明:在考虑各支点支承刚度变差情况下,采用多参数、多目标稳健设计方法,可保证多支点柔性转子系统的临界转速特性在满足设计要求的同时,转子系统临界转速对支承刚度变差的敏感度最低,验证了该方法的有效性。      

低排放燃烧室NO_x排放试验及预测方法研究

为了研究中心分级贫油低排放燃烧室的排放特性和排放预测方法,针对一个低排放头部方案,在单头部燃烧室试验件上,在不同的温度、压力、油气比、供油模式和分级比条件下,测量其排放性能。以Lefebvre排放经验预测公式为基础,采用经验分析方法拟合排放试验数据,归纳出适用于本头部方案的排放预测公式。表征预测好坏的判定系数R2在小工况下和大工况下分别为0.95和0.93,表明预测结果与试验结果符合度较好。小工况和大工况排放特性不同,对仅预燃级喷油的小工况工作模式,NO_x排放主要受化学恰当燃烧温度和预燃级局部当量比的影响;对预燃级和主燃级同时喷油的大工况工作模式,NO_x排放主要受燃烧区温度和主燃级燃油比例的影响。     

Investigation on nonlinear lateral-torsional coupled vibration of a rotor system with substantial unbalance

Substantial unbalance may be caused by fan blade off during the operation period of gas turbine engines, and related dynamic problems are very critical to the safety design of rotor system in aero-engine. This article aims to understand lateral-torsional coupled vibration of the rotor system with substantial unbalance. The governing equation of a modified unbalanced rotor system is established based on Lagrangian approach. Then, a mathematical analytical method is proposed in which a linear approximation is derived and the Floquet theory and Hill’s method are incorporated, from which the modal characteristics of the unbalanced rotor are obtained. The modal characteristics of the unbalanced rotor system are revealed comprehensively for the first time. Furthermore, the relation between the modes and responses of the unbalanced rotor is discussed in detail. The results show that the lateral vibration and torsional vibration of the unbalanced rotor are coupled through the inertial terms in the governing equations. Due to the coupling, veering and lock-in phenomena occur between the frequencies of the forward whirl mode and the torsional mode. Furthermore, lock-in can lead to a kind of principal instability. With regard to the response of the unbalanced rotor, both natural vibration components and enforced vibration components appear in the lateral response, while only natural vibration components appear during torsional vibration. Moreover, natural vibration components play a crucial role in the response within the principal instability region and cause divergence of the vibration amplitudes in the lateral and torsional directions.     

Injection of 40-kHz-modulated electron beam from the satellite: II. Excitation of electrostatic and whistler waves

Beam-plasma interaction effects are studied during the active space experiment with electron and Xe-ion beam injections in an ionospheric plasma. Permanent 40-kHz-modulated electron beam injection occurs simultaneously with a xenon-ion beam injected by the Hall-type plasma thruster operating in a square-pulse mode (100/50 s for a job/pause duration). The unusual behavior of the background charged particle fluxes and wave activity stimulated during the beam-plasma interaction have been registered by the scientific instruments onboard Intercosmos-25 station (IK-25) and Magion-3 subsatellite. The longitudinal and electromagnetic wave instabilities and their mutual relationship are considered in order to explain the observed effects. The excitation of electrostatic waves by the electron injection has been considered for different resonance conditions near the linear stability boundary. Beam-driven electromagnetic instability is responsible for the backward-propagating whistler waves excited via cyclotron resonance. Competition of these two beam instabilities is one of the subjects of the present study.